Disposal Of The Packaging; Requirements On The Installation Site; Electrical Connection - UNITED OFFICE ULGD 350 A1 Operating Instructions Manual

Disposal of the packaging

GB
IE

Requirements on the installation site

Electrical connection

6
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces the amount of waste generated. Dispose of packaging material that is
no longer needed as per the regionally established regulations.
NOTICE
► If possible preserve the appliance's original packaging during the warranty
period so that, in the event of a warranty claim, you can package the appli-
ance ideally for its return.
For safe and fl awless operation of the appliance, the installation site must comply
with the following requirements:
■ When setting it up, place the appliance on a fi rm, fl at and horizontal surface.
■ Place the appliance so that at least 30 cm of space remains unoccupied
behind the laminator. Otherwise the laminating pouch cannot be completely
ejected from the laminator after lamination.
■ Do not operate the appliance in a hot, wet or very humid environment or
close to combustible material.
■ The mains power socket must be easily accessible, so that the power cable
can be easily disconnected in the event of an emergency.
IMPORTANT
► Before you connect the appliance, compare the connection data (voltage
and frequency) on the data plate with that of your mains power network.
This data must match in order to avoid any damage to the appliance.
► Ensure that the power cable is undamaged and is not routed over hot
surfaces and/or sharp edges.
► Ensure that the power cable is not taut or kinked.
► Do not let the power cable hang over edges (trip wire eff ect).
♦ Insert the plug into a mains power socket.
ULGD 350 A1