Craftsman 486.24207 Owner's Manual page 6

• Assemble the height adjustment handle to the
height adjustment tube as shown in fi gure six. Use
two curved head bolts, bowed washers, 5/16" lock
washers and 5/16" hex nuts. Do not tighten yet. See
fi gure 6.
• Assemble the grip onto the height adjustment handle.
See fi gure 6.
5/16" HEX NUT
5/16" LOCK
WASHER
BOWED
WASHER
CURVED
HEAD BOLT
FIGURE 6
• Insert a 5/16" x 3/4" hex bolt through the angle
bracket. Assemble onto the bolt (in sequence) the
spacer bushing, the height adjustment strap, a 5/16"
fl at washer and a 5/16" hex lock nut. Tighten. See
fi gure 7.
5/16" x 3/4"
HEX BOLT
HEIGHT
ADJUSTMENT
STRAP
FIGURE 7
GRIP
HEIGHT
ADJUSTMENT
HANDLE
5/16" FLAT
WASHER
SPACER
BUSHING
5/16" HEX
LOCK NUT
Get other manuals https://www.bkmanuals.com
• Position the height adjustment handle side to side so
that the tooth lock washer can fi t between the handle
and the height adjustment strap. Tighten the nuts
securing the height adjustment handle. See fi gure 8.
• Insert the 5/16" x 1" carriage bolt through the height
adjustment handle. Assemble onto the bolt, in order,
the 5/16" tooth-lock washer, the height adjustment
strap, a 5/16" fl at washer and the plastic knob. See
fi gure 8.
5/16" FLAT
WASHER
PLASTIC
KNOB
TOOTH LOCK
WASHER
FIGURE 8
ASSEMBLY OF HOPPER BAG
• Hold the (LH) upper hopper tube so that the hole
for the brace rod faces down. Insert the (LH) upper
hopper tube down through the stitched fl ap on the
left side of the hopper bag. Repeat for the right hand
upper hopper tube. See fi gure 7.
BRACE ROD HOLE
MUST FACE DOWN
FIGURE 9
6
5/16" x 1"
CARRIAGE BOLT
(LH) UPPER
HOPPER
TUBE
HOPPER
BAG
BOTTOM