IBM TS4300 User Manual page 89

IBM Confidential
Figure 36. Universal rack connector
b. On the inside of the racks, facing out, mount the connectors at the appropriate height to the right
and left rack posts. Mount them in the middle hole of the height unit (the middle of a height unit is
the hole between two wide and neighboring division bars) in both front and back. The four screw
holes must align with the holes on your rack. If they do not, the blocks are not in the correct
location. See Figure 37 on page 57 and Figure 38 on page 58.
Note: If the connectors are installed incorrectly, the screws on the connectors do not match the
holes on the frames. The circles in the graphics highlight the mismatch.
Figure 37. Incorrect connector locations
Chapter 3. Installing 57