Device Setup; Device Number; Device Name; Device Type - Digital Monitoring Products XF6 Series Installation And Programming Manual

Hide thumbs Also See for XF6 Series:

Table of Contents

DEVICE SETUP

DEVICE NO: -

* UNUSED *

TYPE: FIRE

FI EXP

Digital Monitoring Products

Device Setup

This section allows you to define the panels physical configuration. You can install and

address up to fifteen supervised devices on the keypad bus.

Enter the address of the device you are programming. After you program each option for

the first device, repeat these programming steps for each additional device. Programmable

devices are FIRE and EXPANDER. The available addresses are 1 - 16 on the panel keypad

bus.

A device name must be given to each device in the system. To add a device name, press

any select key or area. The default device name (DEVICE XX) displays. Select CMD to

accept the default name or press any select key or area to enter a new name up to 32

alphanumeric characters. Press CMD.

To remove a device from the system, delete the device name by pressing any select key or

area, then press CMD. The panel automatically programs the name as * UNUSED *.

This section allows you to select a device type for the selected device number.

FIRE ‑ A 7830F Fire Command Keypad or 630F Remote Annunciator. See Fire Device

Remote Programming in the XF6 Series Compliance Guide (LT-2779) for instructions on

how to allow remote panel programming.

EXPANDER ‑ A Zone Expansion Module.

XF6 Series Installation and Programming Guide

Table of Contents