Device Setup; Device Number; Device Name; Door Device Type - Digital Monitoring Products XTLplus Series Installation And Programming Manual

DEVICE SETUP

DEVICE SETUP
DEVICE NO:-
* UNUSED *
DEVICE SETUP
DOOR? NO YES

NETWORK?

NO YES

1100T?

NO YES
SERIAL#: XXXXXXXX
1100T FREQ:
HWL 2GIG INT DSC

WIRELESS?

NO YES
SERIAL#: XXXXXXXX
240
SUPRVSN TIME:
SELECT MINUTES:
0 60 240
XTLplus Series Installation and Programming Guide | Digital Monitoring Products
Device Setup
This section allows you to define the XTLplus panel wireless device configuration,
including a door, 1100T Wireless translator, wireless devices, or keypads. You can
install and address up to seven wireless devices.

Device Number

Enter the device number of the wireless device you are programming. The valid range
is 2-8.
Note: Address one is reserved for the XTLplus programming keypad attached
during programming.

Device Name

This section allows you to define a 16-character alphanumeric name for the device
number. If no name is entered, UNUSED is displayed.
To remove a device from the system, delete the device name by pressing any Select
Key or Area, then press CMD. The device name is now displayed as UNUSED.

Door Device Type

When YES is selected, the door device type can be viewed and managed from Virtual
Keypad. This includes 1134 devices. Default is NO.
Network
Select YES to use a 7463 network keypad. Select NO to use a wired or wireless
keypad. Default is NO.
For panels connected over Wi-Fi or Network, one network keypad is is able to
be connected. An error message will display if you attempt to connect additional
network keypads.
1100T
The 1100T allows you to use compatible non-DMP wireless with an XTL Series panel.
Select YES to use an 1100T Wireless Translator. One 1100T Translator is programmable
on devices 2-8 per panel. If an 1100T is programmed, you must select YES in the
Competitor Wireless prompt and enter the Competitor Wireless Serial Number in
Zone Information.
Enter the 1100T serial number and press CMD.
Communication frequencies are HWL (Honeywell), 2GIG, INT (Interlogix), and DSC.
Default is HWL (Honeywell).
Select NO to move to the next prompt. Default is NO.
Wireless
Select YES to use a wireless device. Default is YES.

Serial Number

Enter the eight-digit serial number found on the wireless device.

Supervision Time

Press any top row key to select the supervision time required for the device. Press
CMD to accept the default time. Default is 240 minutes.
Press the Select Key or Area under the required number of minutes. The device must
check in at least once during this time or a missing condition is indicated for that
device. Zero (0) indicates an unsupervised wireless keypad.
Note: When the panel is reset, panel is powered down and powered up, or
programming is complete, the supervision timer restarts for all wireless devices.
20