Advertisement
can choose the options among 1/3/5 min and OFF.
C. G-Sensor: Select the level of G-sensor you need,
then you can set 3 directions (Front + Rear/Left + Right
/Up + Down). The G-sensor value in each direction can
be selected as 1/2/3(default) /4/5/Off. The higher the
sensitivity level, the easier it is to trigger event
recording. The g-sensor is the most sensitive when set
to 5.
D. HDR Timer: The default is off. After turning it on,
you can select the automatic start time and close time.
E. Audio Recording: The default is ON. Set recording to
on or off.
F. Exposure: The default value is +0.0. Adjust the
exposure of the lens.
G. REC Status Light: The default setting is ON. You can
choose to turn on/off the recording status light.
H. HDR: The default is ON. Set to on or off .
I. Rotate Display: Default is off. You can choose to flip
the rear screen up and down (180 degrees).
J. Mirror: The default is ON. If you turn it on, the rear
recording screen will be displayed in mirror mode.
K. Number Plate: Select the number or letter to be set.
After setting, your license plate number can be
displayed in the recorded video.
L. Stamp: Enable or disable the watermark stamp on
video and photos. The watermark stamp includes time
and date label, VANTRUE label, license plate number,
GPS location information, and speed label. All are
enabled by default.
M. Time Lapse: The default value is disabled. You can
choose to enable 1FPS/5FPS/10FPS/15FPS.
N. Parking Mode: You can choose the parking mode
you need, including Collision Detection/Motion
Detection/Low Bitrate Recording/Low Framerate
Mode/OFF, the default is OFF.
O. Low-light Night Vision in Parking Mode: Default is
ON. When turned on, it can optimize the recording
- 15 -
Advertisement
