Canon NP6012 Service Manual page 20

——— SSS SSS GENO AL DESCRIPTION Go
3)
4)
5)
6)
7)
COPYRIGHT © 1995 CANON INC.
If you need to manually adjust the copy
density, deselect AE and use the Copy
Density Adjust lever.
As necessary, press the Default Ratio
key or Zoom key.
a. When you press the Zoom key, '%'
appears on the Copy Count/Ratio
indicator so that you may set the
ratio between 70% and 141% in 1%
increments.
'%' disappears if the Copy Count/
Ratio key is not operated in about 3
sec.
b. When you press the Default Ratio
key, the ratio changes as follows for
each press:
Loe 141%
DIRECT 100%
MARGIN 86%
LGL ® LTR 78%
pe MIN. 70%
(Inch- configuration)
A5 e A4
BS A4/LTR
BS AS/STMT
> > AS
(AB/nch- configuration)
If you are using the multifeeder, press
the Paper Select key.
Check that the '%' notation on the Copy
Count/Ratio indicator has turned off;
then, set the number of copies to make
using the Copy Count/Zcaom Set key.
(The count should appear on the Copy
Count indicator.)
Press the Copy Start key.
a. As may copies as you have speci-
fied will be made automatically.
b. No other keys than the Clear/Stop
key or Copy Density adjustment
lever/AE OFF will be accepted until
CANON NP6O12/NP6OI2F/NP6212 REV.1 SEPT, 1995 PRINTED IN JAPAN (IMPRIME AU JAPON)
the last copy has been made.
c. You may switch from automatic den-
sity adjustment mode to manual
density adjustment mode between
copying has started and the last
copy is made; however, you cannot
switch from manual density adjust-
ment mode to automatic density
adjustment.
d. When copying is finished, the Copy
Count indicator indicates the initial
copy count. If copying stopped as a
result of the absence of paper, a
press on the Copy Start key after
supplying paper will automatically
make the remaining number of
copies.
e. To stop copying operation during
continuous copying, press the
Clear/Stop key; the ongoing copy
run is finished before the operation
stops. (At this time, the Copy Count
indicator indicates the initial count.)
f. If paper jams, the JAM indicator will
flash and copying operation stops;
open the top unit. (The power turns
off when the top unit is opened for
removal of the jam.)
g. After copying operation is over, the
auto power-off mechanism becomes
activated if the copier is left alone for
about 5 min without further key
operation, automatically turning off
the power.
Using Transparencies
Shift the delivery guide plate on the copy
tray upright.
Figure 1-404
1-13