Table of Contents
Advertisement
3) Install the scanning lamp ©) with its
manufacturer's marking © toward the
front. Then, make sure that the contacts
of the lamp are in firm contact with the
contacts of the No. 1 mirror mount.
Figure 4-406
MECHANICAL SYSTEM May
4) After installing the scanning lamp, push
the four corners of the No. 1 mirror
mount @ lightly to make sure that the
slider is in contact.
Figure 4-407
5) If the slider is not in firm contact, try the
steps to install the scanning {amp once
again.
COPYRIGHT © 1995 CANONINC.
CANON NP6O12/NPGO12E/NPG212 REV. SEPT. 1995 PRINTED
IN JAPAN (IMPRIME AU JAPON)
4-33
Advertisement
Chapters
Table of Contents
