Table of Contents
Advertisement
Using This Manual
This manual contains device usage instructions.
Some illustrations shown in this manual may contain modules and optional equipment that are not included
in your system.
Conventions
The following conventions are used.
Notes
A NOTE provides helpful information such as additional explanations, tips, and comments.
Example:
Note: In general, vehicle identification numbers are standardized - all contain 17 characters. VIN
characters may be capital letters A through Z and numbers 1 through 0; however, the letters I, O and Q
are never used in order to avoid mistakes of misreading. No signs or spaces are allowed in the VIN.
Warning
WARNING indicates a hazardous situation which, if not avoided, could result in minor or moderate injury to
the operator or to bystanders.
Example:
Warning: Retrieving and using DTCs for troubleshooting vehicle operation is only one part of an overall
diagnostic strategy. Never replace a part based only on the DTC definition. Each DTC has a set of testing
procedures, instructions and flow charts that must be followed to confirm the location of the problem. This
information can be found in the vehicle's service manual.
Danger
DANGER indicates an imminently or potentially hazardous situation which, if not avoided, could result in
death or serious injury to the operator or to bystanders.
Example:
Danger: If you must drive the vehicle in order to perform a troubleshooting procedure, always have
a second person help you. Trying to drive and operate the diagnostic tool at the same time is dangerous,
and could cause a serious traffic accident.
Illustrations
Illustrations used in this manual are samples, the actual testing screen may vary for each vehicle being
tested. Observe the menu titles and on-screen instructions to make correct option selection.
Compliance Information
FCC ID: 2AUKMMAXFLEXPRO
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
2311226-16
II
User Manual
www.matcotools.com
MDMAXPROHD
877-853-3738
Advertisement
Table of Contents
