Wiper Switch - BYD SEAL 2023 Owner's Manual

Wiper Switch

Front Windscreen Wipers and Washer
The lever is used to control the
●
windscreen wipers and washer. It has
five modes:
: Fast
●
: Slow
●
: Auto wipers/intermittent
●
: Off
●
: Point-wiping
●
Push up or pull down the lever to
●
select a mode.
In slow and fast modes, the wiper
●
operates continuously.
Pulling down the lever from the
●
position activates the point-wiping
mode . The wipers wipe at a low
speed until you release the lever.
Auto wipers/Intermittent
The rain sensor automatically controls
●
the operation mode of wipers based on
the rainfall, and it is located in front
of the interior rearview mirror on the
front windscreen inside the vehicle.
To use the automatic wiper function,
●
turn the wiper switch to the automatic
mode, go to infotainment touchscreen
70
→ → Vehicle Settings → Greeting
and toggle Automatic Wiper on.
To use the intermittent wiper function,
●
turn the wiper switch to the automatic
mode, and toggle Automatic Wiper off
in infotainment touchscreen →
Vehicle Settings → Greeting.
The automatic wiper function has four
●
sensitivity levels. The higher the lever,
the higher the sensitivity. When using
the automatic wiper function, change
the sensitivity by adjusting the toggle
based on real-time rain conditions. If
the wiper reacts to rain too quickly,
reduce the sensitivity; if the wiper
reacts to rain too slowly, increase the
sensitivity.
Front windscreen wipers and washer
To clean the front windscreen, pull the
●
wiper switch lever backward (towards
the steering wheel) so that the washer
spray washing fluid while the wipers
operate.
The washer spray will stop when the
●
stick is released, and the wipers will
operate twice then stop.
→