BYD SEAL 2023 Owner's Manual page 62

② Seatback angle adjustment switch
Toggle the seatback angle adjustment
●
switch to adjust the angle.
REMINDER
Releasing the switch stops the
●
seat in this position. Do not
place anything under the seat as
this may prevent the seat from
operating.
Adjusting the lumbar support*
The seatback profile can be adjusted to
fit the curvature of the occupant's lumbar
spine.
Press the front or rear portion of the
●
switch to increase or decrease the
curvature.
Press the upper or lower portion of the
●
switch to extend the curvature up or
down.
Memory System*
Memory switch position
The memory system switch is on the
infotainment touchscreen with 2 memory
positions: 1 and 2.
Setting function
Memory setting conditions
●
The vehicle is powered on with no
●
vehicle speed.
The driver's seat, side mirrors and
●
steering wheel have been adjusted to
the desired positions.
No operation is made on the driver's
●
seat, side mirrors and steering wheel.
Memory setting method
Memory setting in OK mode
●
Press the "SET" button on the seat
●
memory switch, and press either "1"
or "2". Then the positions of the seats
and side mirrors will be remembered,
and the memory setting finishes.
Press and release the "SET" button
●
on the seat memory switch, and
press either "1" or "2". Then the side
mirrors memory system is activated.
If the position button on the memory
switch has already been set, the position
set will be overwritten.
Memory wake-up function
Memory wake-up function in OK mode
With the gearshift lever in the "P"
●
position, tap 1 or 2 for the memory
system to restore to the previous
position of the driver seat and side
mirrors if the following conditions are
met:
The vehicle is not in anti-theft mode.
●
No speed.
●
Memory switch signals are valid.
●
03
61