BYD SEAL 2023 Owner's Manual page 43

Hide thumbs Also See for SEAL 2023:
Table of Contents

Advertisement

REMINDER
ESC system is malfunctioned at
this time and braking will cause
instability.
Driving power limit warning light
When the power of the vehicle is
limited, this warning light comes on.
In this case, contact a BYD authorised
dealer or service provider in time.
Headlight fault warning light
When the warning light is yellow, it
indicates the headlight is faulty, and it
is recommended to bring the vehicle
to a BYD authorised dealer or service
provider for inspection.
Blind spot detection (BSD)
indicator
When this indicator is on, it is
recommended to bring the vehicle to
a BYD authorised dealer or service
provider for inspection.
Main alarm indicator
If this indicator goes on, check the fault
prompt or warning on the instrument
cluster.
Driver attention warning (DAW)
light
Driver attention warning (DAW) system
evaluates the driver's degree of fatigue
by the vehicle operation status. The
driver would be reminded according to
the evaluation results to ensure driving
safety.
42
CPD indicator/warning light*
CPD indicator*: If child presence
detection (CPD) is turned off, the
indicator is solid on, and the OFF
reminder lasts for five seconds. Tap ON
or Delay. The indicator turns off and
CPD is enabled.
CPD warning light*: If the CPD fault
reminder lasts for five seconds and
the indicator is solid on, it indicates
that the CPD system fails. It is
recommended to bring the vehicle to
a BYD authorised dealer or service
provider for inspection.
Seat belt reminder indicator
With the ignition switched on, if any
passenger on the front seats or rear
seats* has not buckled up, the seat belt
reminder lights up. It remains on until
the seat belt is fastened.
Airbag fault warning light
With the ignition is on, this warning
light turns on and then goes off
in a few seconds if the airbag
system is working properly. This
warning light is used to monitor the
airbag ECU, collision sensors, inflation
device, warning lights, connections,
and power supply.
If any of the following cases occurs, it
means there is a fault in components
monitored by the warning light system.
In that case, contact a BYD authorised
dealer or service provider for vehicle
inspection as soon as possible.
When the ignition is switched on, this
warning light remains off or is solid
on after the ignition is switched on.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents