WARNING
Protect the cameras from any
●
impact to prevent damage or
malfunction.
After the vehicle is powered on,
●
if you press the panoramic view
start button or shift into reverse
while the infotainment system is
not fully activated, the output on
the panoramic view screen will
be delayed or the screen will
flash. This is a normal part of the
camera power-on process.
Parking Assist System
During vehicle parking, the parking
●
assist system detects obstacles by
sensors, and prompts the driver with
the proximity of obstacles by an image
on the infotainment touchscreen and a
speaker alarm.
The parking assist system helps
●
with reversing. Pay attention to the
environment behind and around the
vehicle when reversing.
When you reverse the vehicle, a
●
reversing image will be displayed on
the system screen automatically.
After reversing ends, the interface will
●
be restored.
REMINDER
The safety lines for reversing are
●
only for distance reference in no-
load condition of the vehicle.
For your driving safety, when the
●
reversing image is displayed, all
buttons will be disabled except
some volume and calls-related
buttons.
WARNING
The parking assist system ceases
●
to operate when the vehicle is
moving forward at over 6 mph (10
km/h).
Do not place any articles within
●
the sensors' working range.
Do not wash the positions of
●
sensors with water or steam when
washing the vehicle, otherwise it
would cause a sensor failure.
Parking Radar Switch
To enable or disable the parking
●
radar system, go to infotainment
touchscreen →
Assist.
When the ignition is on and EPB is
●
released, the parking assist system is
enabled automatically.
When enabled, the system raises
●
an alarm if obstacles are found
surrounding the vehicle; when
disabled, it does not.
Sensor Type
When the sensor detects an obstacle,
●
an image is displayed on the
infotainment touchscreen* according
to the location of the obstacle and its
distance from the vehicle.
When the driver conducts parallel
●
parking or reverse parking, the
→ ADAS → Parking
135
04