Table of Contents
Advertisement
Giant Scale Cessna O-1 Bird Dog 122" ARF 70-125cc
Remove the ailerons from the wing and
remove the hinges.
Use a small piece of rough sandpaper to
scuf the hinges for better epoxy adhesion.
Do this to all aileron hinges.
3.
Apply epoxy to each hinge where it will
be inserted into the ailerons. Tip: Apply
some petroleum jelly to the metal pin
hinge area to keep epoxy from interfering
with smooth operation of hinge.
4.
Insert all four hinges in the ailerons at
this time. Make sure hinges move up and
down in right direction and not side to
side !
5.
6
Epoxy
Epoxy
Apply epoxy into each of the holes in the
ailerons using a spare piece of pushrod
wire or toothpick.
Make sure to use enough epoxy so it
securely adheres the hinge to the surfaces.
Do not use an excessive amount of epoxy
when gluing the hinges so that it expels
from the hinge area.
6.
Be sure to test the aileron hinges once
you insert them. Ensure that the hinge
pockets line up, and that the hinges move
freely before the epoxy dries.
7.
8.
Instruction Manual.
Epoxy
Advertisement
Table of Contents
