Seagull Models SEA385 Assembly Manual page 11

Attach the lap servo to the lap servo
cover. Center the lap servo (or set the
values to 0 for both up and down) and in-
stall the servo arm perpendicular to the
servo centerline. he clevis will attach to
the arm 13/16 inches (21mm) from the
center of the arm.
4.
5.
Attach the lap linkage to the control
horn. Slide the clevis retainer over the
forks of the clevis.
6.
M3x15mm
Attach the clevis to the lap servo arm.
7.
Use a pin vise and 3/32-inch (2mm)
drill bit to clear the paint from the lap
control horn.
8.
Route the servo lead for the lap servo
out at the root of the wing. Connect the
lap servo to the radio system. With the
radio system on, place the lap servo into
position.
9.
11