Advertisement
Step 12
Step
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right diagram. If
it isn't, loosen the adjusting screw and mounting screw to slide it against the stops. Then tighten the mounting screw.
å
Fasten a DOOR (K) to the UPRIGHT (C) as shown in the lower diagram. Use the screws in the HINGES. You should start
each SCREW a few turns before completely tightening any of them.
å
Repeat this step for the other DOOR (K).
å
Peel the BUMPERS from the remaining BUMPER CARD (29M). Stick the BUMPERS on the FIXED SHELF (D) where it
comes into contact with the INNER DOORS (K).
å
See the next step for DOOR adjustments.
29M
K
K
C
D
Stop
Mounting
screw
Adjusting
screw
Hinge
Page 17
Advertisement
