Installing The Sim Card - Teldat 5Ge-Rail Installation Manual

Teldat S.A.

3.6 Installing the SIM Card

The Teldat 5Ge-Rail router features a Wireless WAN interface that requires one or two SIM cards for operation.
On the front panel of the Teldat 5Ge-Rail , you will find two protected SIM trays, as shown in the following figure.
Fig. 14: SIM trays
The assignment for the SIM trays is as follows:
• SIM1: Upper Slot
• SIM2: Lower Slot
To insert or remove a SIM card in the internal SIM card slots, follow these steps:
(1) Begin by removing the SIM slot cover located on the front of the device. You can do this using a TORX T8
screwdriver to loosen the screw securing the cover. Once the screw is loose, simply remove the cover.
(2) Next, either press to insert the SIM card into the desired tray or press to remove it from the tray.
(3) Once the SIM card is in place or removed, reinsert the card slot cover and ensure it is secure by tightening the
screw.
Warning
Never install the SIM cards while the device is powered on.
Prior to inserting the SIM cards, always disconnect the device from the main power supply.
Additionally, make sure to disconnect the device before removing the protective casing to access the
trays.
When inserting the SIM cards, please take precautions to guard against electrostatic discharges (ESD).
Do not touch the SIM card connectors.
Teldat 5Ge-Rail
3 Components and Power Supply
17