Table of Contents
Advertisement
Appliance Preparation and Start-Up
1. Before use, clean the appliance and accessories thoroughly, following
indications in section 6 'Cleaning and Maintenance'.
2. Then dry the appliance thoroughly.
3. Plug the appliance into a suitable single socket.
4. Switch the appliance on by setting the switch at the front of the appliance in 'I'
(ON) position.
The green power indicator light in the ON/OFF switch lights up.
The digital display shows current temperature inside the appliance.
The
LED indicator light blinks for 3 minutes during the delay between the
compressor stopping and restarting.
5. Switch the appliance on (without food products). Observe the notes in the
following chapters of the operating manual to set the desired parameters.
6. Before first use and before putting any food products into drawers and the
cabinet, the appliance should reach the set temperature.
Control Elements and Displayed Messages
EN
Key
16 / 24
Functions
Showing the set value, selection of parameters in the
programming mode or confirmation of the process
Manual start of defrosting
Selection of the parameter code in the programming
mode, increase of the displayed value
Selection of the parameter code in the programming
mode, decrease of the displayed value
Installation and operation
200297
Advertisement
Table of Contents
