Table of Contents
Advertisement
IP Rating
Maximum Temperature (Storage)
Maximum Temperature (Operating – Heating Models)
Maximum Temperature (Operating – Ambient Models)
Relative Humidity
INSTALLATION
Horizontal Style
The Invisidor Style
Air Curtain should be surface mounted inside the doorway and not exposed to the
2
external environment or moist conditions. It should not be built-in or recessed in any way.
Location
Ensure that the unit is mounted within its height specification of 1.8m to 3.2m maximum (from floor level
to the underside of the unit) with the air discharge grille positioned nearest to the door. The air curtain
should be located as close to the door opening as possible for best performance, obstructions such as
door opening devices, structural beams etc will reduce the efficiency of the air curtain. There must be
at least 200mm clearance at the air inlet for air to enter the air curtain.
For maximum effectiveness it is essential to ensure the width of the air curtain is slightly wider than the
width of the door when it is open.
Using the 2.5mm hexagon key wrench supplied, unfasten and remove all casing screws from air curtain
inlet grille and carefully detach the casing. All screws should be kept safe as they will be required later
in the installation.
Version 5.0 (Original Manual)
INVISIDOR STYLE
2
Unit Operation Conditions
Air Curtain
2
Back Panel
AIR CURTAIN: Installation, Operation & Maintenance Instructions
Inlet Grille Panel
IP20
C – 60
o
o
-10
C
C – 30
o
o
0
C
C – 40
o
o
0
C
95% Non-Condensing
Page | 6
Advertisement
Table of Contents
