McLaren Super Series Owner's Handbook Manual page 99

Driving Controls
Handling and Powertrain Controls
3. Press the ACTIVE button to switch on the
Active Dynamics Panel.
4. Press the LAUNCH button.
NOTE: will flash in the gearbox mode
L
indicator, see Manual/automatic mode,
page 2.18 and Launch Mode active -
Awaiting full throttle' will be shown on
the Folding Driver Display.
5. With your left foot remaining on the brake
pedal, press and hold the accelerator pedal
down fully with your right foot, the engine
speed will increase to 3,200 rpm.
NOTE: To abort launch control release
the brake pedal before pressing the
accelerator pedal or wait for
approximately 100 seconds until launch
control is deactivated. The message
Launch Mode aborted - See owner's
manual' will be shown on the Folding
Driver Display.
NOTE: The message Launch Mode
active - Boost building' will be shown
on the Folding Driver Display. Once
sufficient boost has been achieved, the
message Launch Mode active - Boost
ready' will be shown on the Folding
Driver Display.
6. Release the brake pedal with your left foot
and the launch control system will perform
a launch start to give maximum
acceleration.
NOTE: To abort launch control release
the accelerator pedal or wait for
approximately 5-10 seconds until
launch control is deactivated. If the
launch is aborted, release the
accelerator pedal and then press again
to drive away. The message Launch
Mode aborted - See owner's manual' will
be shown on the Folding Driver Display.
2.27