McLaren Super Series Owner's Handbook Manual page 66

Before You Drive
Washers and Wipers
1. For a slow single wipe, briefly push the
wiper stalk down and release. The wipers
will operate once at slow speed, without
washers.
2. For a fast single wipe, push and hold the
wiper stalk down. The windscreen wipers
will perform a continuous fast wipe until
the stalk is released.
Windscreen wash/wipe
Pull the wiper stalk towards you.
1.56
The windscreen washers and wipers will initially
operate at a slow speed while the stalk is held.
If the stalk is held for more than 2 seconds, the
wiper will operate at high speed.
When the stalk is released, the wipers will
complete their cycle and return to the parked
position. After a period of time the wipers will
operate once more to wipe any remaining
washer fluid from the windscreen.
NOTE: The position of the washer jets
are set during vehicle manufacture and
should not need adjusting. If a problem
occurs, consult your McLaren retailer.
Wiper park positions
In addition to the normal park position, there are
two alternative positions.
Ensure the vehicle is in Locked, Sleep or Awake
mode.
Pull the wiper control stalk towards you, the
wipers will move through the following park
positions each time the stalk is pulled:
Winter park
The wipers are parked vertically to reduce the
risk of damage to the wiper arms during periods
of heavy snowfall and provide access for easier
cleaning of accumulated snow.
Service park
The wipers are parked diagonally to provide
access for replacing the wiper blades, see
Replacing the wiper blades, page 6.33.
Normal park
The wipers are parked horizontally along the
lower edge of the windscreen.