McLaren Super Series Owner's Handbook Manual page 200

Central Display
Garage Door Opener
3. Press and hold the button on the garage
door opener remote control, 'Remote
successfully learned' will be displayed on
the Central Infotainment Touchscreen and
the exterior lights will flash. Release the
garage door opener remote control button.
NOTE: Some remote device systems
require the operator to press and
release the garage door opener remote
control button every 2-10 seconds
during programming.
4.50
4. Press the programmed HomeLink button,
if the device activates, programming is
complete, if the device does not activate,
continue with steps 5 to 7.
5. Locate the learn or smart button on the
motor-head unit, located on the garage
door opener's receiver. Refer to the garage
door opener manual to identify the learn
or smart button.
6. Press and release the learn or smart button.
There are typically 30 seconds to initiate
Step 7.
7. Return to the vehicle. Press and release the
programmed HomeLink button every 2
seconds up to five separate times to
activate the device. If the device activates,
programming is complete.
Erasing all programmed garage door openers
To erase all previously programmed garage door
openers:
1. From the garage door opener screen press
to display the Settings menu.
2. Press 'clear all buttons' .
3. Previous settings of all three buttons have
now been erased.
HomeLink® and the HomeLink® house icon are
registered trademarks of Gentex Corporation.