McLaren Super Series Owner's Handbook Manual page 22

Before You Drive
Opening and Closing
3. From the side of the vehicle, grasp the two
rear edges of the service cover and rotate
the service cover upwards towards the rear
windscreen to remove.
NOTE: Place the service cover inside the
vehicle to avoid the risk of damage.
See Engine oil, page 6.04.
See Coolant, page 6.07.
1.12
Installation
WARNING: The exhaust tail pipes can
be very hot and there is a risk of
severe burns. Only install the service
cover from the side of the vehicle.
1. Position service cover centrally on the back
of the vehicle.
2. Apply pressure to the service cover as
shown. Positive clicks will be heard when
the two fixings engage.
3. Insert the service cover release tool into
each fixing located underneath the lower
corners of the service cover. Push down
and rotate each fixing clockwise until a
positive click of engagement is heard to
latch both sides of the service cover.
4. Ensure service cover is secure once
installed.