My Board Is Not Booting - What Now - Aaeon UP Xtreme i11 Getting Started Manual

Hide thumbs Also See for UP Xtreme i11:

Table of Contents

My board is not booting – what now?

Once in a while, especially during an intense debug session, we have found that the

target goes into la-la land. You get to the UP splash screen, and then it just stops. Or

the screen stays black. SourcePoint run-control continues to work, but it won't boot all

the way up to the UEFI shell. Quitting SourcePoint, unplugging the DCI cable, killing the

AssetDCI process – all are good steps in this instance, when you need to recover.

But then, once in a while, you wait the needed 20 seconds; and it doesn't boot. The

screen stays blank or frozen.

Don't panic! For reasons we're not sure of just yet, after about 60 seconds, the board

"wakes up" and should boot all the way to the UEFI shell.

Clearing the CMOS on the target has also been known to help when it still won't boot

up.

There's only one thing: it has gone back to the factory settings, so you need to reset the

WDT timer, as per

BIOS Settings

section in this manual.

Then, you'll be back in business.

SourcePoint Getting Started Guide – UP Xtreme i11

Table of Contents