Aaeon UP Xtreme i11 Getting Started Manual page 10

before booting all the way up to Windows. In this case, press F7 after powering on to
stop at the BIOS setup.
For the v0001 board, the ball will be yellow, versus the green. This is due to a flash
firmware strap setting, which changes the target behavior somewhat, as you'll see
below; but otherwise does not affect UEFI debugging.
Is the ball still red? Try cycling power on the target (don't just power cycle with the reset
button; physically remove the power plug, then plug it back in again). Still red? See our
Troubleshooting section.
©2023 ASSET InterTech, Inc.
10
SourcePoint Getting Started Guide – UP Xtreme i11