Personnel Qualifications; Electrical Work; Transport - Wilo Atmos GIGA-NHT Installation And Operating Instructions Manual

Table of Contents

Advertisement

en
2.2

Personnel qualifications

2.3

Electrical work

2.4

Transport

6
Personnel must:
Be instructed about locally applicable regulations governing ac-
cident prevention.
Have read and understood the installation and operating in-
structions.
Personnel must have the following qualifications:
Electrical work: A qualified electrician must carry out the elec-
trical work.
Installation/dismantling must be carried out by a qualified tech-
nician who is trained in the use of the necessary tools and fixa-
tion materials.
Definition of "qualified electrician"
A qualified electrician is a person with appropriate technical edu-
cation, knowledge and experience who can identify and prevent
electrical hazards.
Electrical work must be carried out by a qualified electrician.
When connecting to the mains, comply with the locally applic-
able laws and regulations of the local energy supply company.
Before commencing work, disconnect the device from the
mains and secure it against being switched on again without
authorisation.
Train personnel on how to make the electrical connection as
well as on the methods for switching off the device.
Observe the technical information in these installation and op-
erating instructions as well as on the rating plate.
Earth the device.
Observe the manufacturer's specifications when connecting to
electrical switching systems.
Comply with the specifications on electro-magnetic compatib-
ility when using electronic start-up controllers (e.g. soft starter
or frequency converter). If required, take into account special
measures (shielded cables, filters, etc.).
Replace defective connection cables. Contact customer service.
Wear protective equipment:
Safety gloves for protection against cuts
Safety shoes
Sealed safety goggles
Safety helmet (when using lifting equipment)
Only use legally specified and approved lifting gear.
Select lifting gear based on the available conditions (weather,
attachment point, load, etc.).
Always attach the lifting gear to the designated attachment
points (lifting eyes).
Installation and operating instructions • Wilo-Atmos GIGA-NHT • Ed.01/2023-10

Advertisement

Table of Contents
loading

Table of Contents