Table of Contents
Advertisement
Anchor 7000
Installation Manual
Installation and Commissioning Manual
If a signal lock with "release enabled" (switching logic) has been set up, this will ensure that
the lock is not automatically switched off if the control cable is cut through. At the same, a
cable breakage within the safe thus always entails the risk of a block.
You can find the configuration of the signal interfaces in the Operation Manual.
(03 Axxx – Operation Manual V3.00 Chap. 6-2 and 6-2).
02 A7000-Part 2b-Installation Manual V1.04
Figure 4 - Assignment of the alarm interface
8 / 10
Advertisement
Table of Contents
Need help?
Do you have a question about the Anchor 7000 and is the answer not in the manual?