Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Wittkopp BlueCam greendot
Summary of Contents for Wittkopp BlueCam greendot
- Page 1 Operating Instructions BlueCam greendot Changing users www.carl-wittkopp.com...
- Page 2 8 Power supply and battery change Legend LED flashes green LED is permanently green LED flashes red LED is permanently red Tone signal © Carl Wittkopp GmbH - errors and omissions excepted 20.06.2011 Operating Instructions No. 9999-084-0...
- Page 3 BlueCam Operating Instructions greendot 1 General instructions • Please read the operating instructions carefully, before activating the lock. • The lock is supplied with the following factory codes: - User factory code: 1-2-3-4 master factory code: 1-2-3-4-5-6 master factory code: 6-5-4-3-2-1 For your security, change the factory codes immediately.
- Page 4 BlueCam Operating Instructions greendot 2 Locking At any time upon locking a 4-digit user code can be chosen. 1. Press the ON-button. 2. Enter a 4-digit user code within 10 seconds. 3 seconds 3. Turn the handle within 3 seconds. The lock is opened. 4.
- Page 5 BlueCam Operating Instructions greendot 4 Opening after 4 wrong code entries After 4 wrong code entries the lock is blocked for 30 seconds. During this time it is not possible to enter a code. At the end of the blocked time the red LED goes out ...
- Page 6 BlueCam Operating Instructions greendot 6 Opening with the 2 master code The 2 master code is only necessary if the lock is locked and the user code is not available. By entering the 2 master code the user code is still valid. Keep the ON-button pressed until the LED lights up permanently green.
- Page 7 BlueCam Operating Instructions greendot 7 Changing the 1 and 2 master code The lock can be operated with one or two master codes. One master code: master code and 2 master have to be the same code. During reprogram- ming the 1 master code will be deleted.
- Page 8 BlueCam Operating Instructions greendot 8 Power supply and battery change The lock is operated with a 9 volt alkaline battery. We recommend using a battery with reduced heavy metal concentration. If the LED flashes red after pressing the ON-button, the battery voltage is low. Change the battery as soon as possible.
Need help?
Do you have a question about the BlueCam greendot and is the answer not in the manual?
Questions and answers