Advertisement
O
REFI
A11ach the Core Filter(s) (if provided with your model _
pg. 5) to an optional cable(s). The Core Filter reduces
interference.
Stopper
Release the
stoppers
on both
ends of the Core
Filter.
]
3 cm
Wind once
Run the cable through the Core Filter, leaving approx. 3 cm
of cable between the cable plug and the Core Filte_ Wind
the cable once around the outside of the Core Filter as
shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage
the cable.
[]
Close the Core FiBer until it
clicks shut.
• When connecting
cables, attach the end with the Core Filter to the camcorder.
ATIC BEMONSTRATION::
Automatic Demonstration
takes place when
"DEMO MODE" is set to "ON" (factory-preset).
• Automatic Demonstration
starts when there is no operation for
about 3 minutes after the Power Switch _ is set to "0"
or" []"
and no cassette is in the camcorder.
• Performing any operation during the demonstration
stops the
demonstration
temporarily.
If no operation is performed for more
than 3 minutes after that, the demonstration
will resume.
• "DEMO MODE" remains "ON" even if the camcorder power is
turned off.
• To cancel Automatic Demonstration:
1. Set the Power Switch _ to "[]"
while pressing down the Lock
Button _) located on the switch and press the MENU/VOLUME
wheel I_ in. The Menu Screen appears.
2. Rotate the MENU/VOLUME
wheel I_ to select "[;_ (SYSTEM)"
and press it.
3. Rotate the MENU/VOLUME
wheel I_ to select "DEMO MODE"
and press it. The Sub Menu appears.
4. Rotate the MENU/VOLUME
wheel I_ to select "OFF" and press
it.
5. Rotate the MENU/VOLUME
wheel I_ to select "tJ RETURN",
and press it twice. The normal screen appears.
Sub Menu
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic
Demonstration
activated on
the LCD monitor or viewfinder.
EN
6
Advertisement
