Advertisement
It is also possible to copy recorded scenes from this
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if
any image or sound deterioration.
To Use This Camcorder As A Player
I Make sure all units are turned off. Connect this
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the ilustration.
2 Set this camcorder's MIDEO/DSC Switch O to
"VIDEO" (GR-D90/D7O only), then the Power Switch (_)
to "PLAY" while pressing down the Lock Button l_
located on the switch, turn on the video unit's power,
and insert the appropriate cassettes in this camcorder
and the video unit.
3 Press 1_O to play back the source tape.
4 While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
NOTES:
• It is recommended
to use the AC Adapter as the
power supply instead of the battery back (_
pg. 7).
• If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. TO prevent this from happening,
press
the buttons on both units.
• If a blank portion or disturbed
image is played back on
the player during dubbing, the dubbing may stop so that
an unusuat image is not dubbed.
• Even though the DV cable is connected
correctly,
sometimes
the image may not appear in step 4. If this
occurs, turn off the power and make connections
again.
• If "Playback
Zoom" (_c_ pg. 14, 35), "Playback
Special
Effects" (GR*D90/D70
only, _-2 pg. 35) or "Snapshot"
is
attempted
during playback, only the originaI playback
image recorded on the tape is output from the DV
connector
_).
• When using a DV cable, be sure to use the optional
JVC VC-VDV204U
DV cable.
To Use This Camcorder As A Recorder
1. Set this camcorder's VIDEO/DSC Switch O
(GR-DgO/D7O only) to "VIDEO", then the Power
Switch _) to "PLAY" while pressing down the Lock
Button _ located on the switch.
2. Set "REC MODE" to "SP" or "LP" in the Menu
Screen (_
pg. 31).
3. Connect the DV cabte as shown in the illustration
and load a cassette to record on.
4. Press the Recording Start/Stop button _ to
engage the Record-Pause mode. "OY.IN" appears
on the screen.
5. Press the Recording Start/Stop button _ to start
recording. O _ rotates.
6. Press the Recording Start/Stop button _) again to
engage the Record=Pause mode. r,_, _ stops
rotating.
NOTES:
• Digital Dubbing is performed
in the sound mode recorded
on the original tape, regardless of the current "SOUND
MODE" setting (_
pg. 28).
• During Digital Dubbing, incoming signals cannot be
output through the video or audio connectors
if they are
copy-guarded.
Core filter--
DVcable
(optional)
Core filter
TODV
IN/OUT
Video unitequipped
with DV connector
EN
34 DUBBING
Advertisement
