Advertisement
• The Sepia or Monotone mode is activated.
--* Turn off Sepia and Monotone (_
pg. 23).
• When shooting in the dark, the unit becomes highly
sensitive to light and the image takes on an effect
similar to Slow Shutter.
--* If you want the lighting to look more natural, set
GAIN UP to "AGC" or "OFF" in the Menu Screen
(_
pg. 29).
• The Sepia or Monotone mode is activated.
-* Turn off Sepia or Monotone before setting White
Balance (_ pg. 23, 27).
• This is a result of exceedingly high contrast, and is
not a malfunction.
• This is not a malfunction.
• in places subject to low temperature, images become
dark due to the characteristics of the LCD monitor.
When this happens, the displayed colors differ from
those that are actually recorded. This is not a defect of
the camcorder.
• When the LCD monitor's fluorescent light reaches the
end of its service life. images on the LCD monitor
become dark. Consult your nearest JVC dealer.
Adjust the brightness and angle of the LCD monitor
(_1_pg. 12).
• The light used to illuminate the LCD monitor causes it
to become hot.
Close the LCD monitor to turn it off or set the Power
Switch _) to "OFF (CHARGE)", and let the unit cool
down.
• "DATE/TIME" is set to "OFF" in the Menu Screen.
-* Set "DATEJTIM E" to "ON" in the Menu Screen
(_
pg. 30. 32).
• Files stored on the memory card are protected.
_* Remove protection from the files stored on the
memory card and delete them (L__ pg. 20).
• "TIME CODE" is set to "OFF" in the Menu Screen.
-* Set "TIME CODE" to "ON" in the Menu Screen
(_
pg. 31.32).
• This may occur when the surface or the edge of the
LCD monitor is pressed.
• Certain Fade/Wipe effects, certain modes of Program
AE with special effects. "DIS" and other functions that
cannot be used together are selected at the same
time.
Re-read the sections covering Fape/Wipe effects,
Program AE with special effects and "DIS"
(_
pg. 23, 24. 29).
• The LCD monitor and the viewfinder are made with
high-precision technology. However, black spots or
bright spots of light (red, green or blue) may appear
constantly on the LCD monitor or the viewfinder.
These spots are not recorded on the tape. This is not
due to any detect of the unit. (Effective dots: more
than 99.99 %)
• This is normal.
• The Power Switch _) is set to "_"
or "_".
Set the Power Switch _) to "PLAY" (_
pg. t4).
EN
TROUBLESHOO_NG 3_
Advertisement
