Advertisement
WARNING INDICATIONS
Displays the battery remaining power level. AS the
battery power comes close to nil. the battery indicator
blinks (battery power warning). When the battery
power is exhausted, power turns off automatically.
Appears when no tape is loaded.
(_
pg. 9)
Appears when the erase_rotection
tab is set to "SAVE"
while the Power Switch f._ is set to "O" or "[]"
and
the VIDEO/DSC Switch O (GR-Dg0/D70 only) is set to
"VIDEO".
(_7_pg. 9)
•Appears if Audio Dubbing is attempted on a tape
recorded in the LP mode.
•Appears if Audio Dubbing is attempted on a tape
recorded in 16-bit audio.
•Appears if A. DUB (=) _ on the remote control is
pressed when the erase protection tab is set to
"SAVE".
(_
pg. 36)
Appears if Insert Editing is attempted on a blank portion
of a tape.
(_
pg. 36)
Appears if dirt is detected on the heads during
recording or playback. Use an optional cleaning
cassette.
(_
pg. 42)
Appears if condensation occurs. When this indication is
displayed, wait more than 1 hour until condensation
disappears.
Appears if a tape is not loaded when the Recording
Start/Stop Button _ or SNAPSHOT Button _ is
pressed while the Power Switch _) is set to "O"
or
"[]"
and the VIDEO/DSC Switch O (GR=Dg0/D70
only) is set to "VIDEO".
Appears when the tape ends during recording or
playback.
• Appears when the date/time is not set.
(_
pg. 10)
• Appears when the built=in clock battery runs out and
the previously set date/time is erased. Consult your
nearest JVC dealer for replacement.
Appears for 5 seconds after power is turned on if the
lens cap is attached.
Appears if Audio Dubbing is attempted on a blank
portion of a tape.
(_
pg. 36)
•Appears if Insert Editing is attempted on a tape
recorded in the LP mode.
•Appears if INSERT (O) _) on the remote control is
pressed when the erase protection tab is set to
"SAVE".
(_
pg. 36)
Appears when the memory card's memory is full and
shooting is not possible.
Appears if dubbing of copyguarded signals is at-
tempted while this camcorder is being used as a
recorder.
Appears in the following cases when dubbing from a
tape to a memory card:
-when no memory card is loaded.
- when the memory card's memory is full.
- when the memory card is not formatted.
Appears if there is no memory card loaded when you
attempt to record on a memory card or access data on
a memory card.
Appears when there is a problem with a memory card
and its memory is corrupt, or it has not been initialized.
Initialize the memory card.
(_#_pg. 22)
Appears if there are no image files stored on the
memory card when you attempt memory card
playback.
EN
50 INOEX
Advertisement
