Quick Reference - Supermicro SuperServer SYS-220TP-HTTR User Manual

Quick Reference

Jumper Description
JBT1 CMOS Clear
10Gb LAN1/LAN2 AUX Power Enable/Disable
*Please consult Supermicro before enabling this
JPAUX1
jumper. There must be sufficient airflow to enable
JPAUX1 in standby mode (S5 state).
JPME2 ME Manufacturing Mode
JPTG1 10Gb LAN1/LAN2 Enable/Disable
Connector
BMC_LAN
BT1
COM1
FAN3, FAN4
JHS1
JIPMB1
JNCSI1
JRK1
JSD1, JSD2
JTPM1
JUIDB1
LAN1, LAN2
I-SATA4, I-SATA5
S-SATA0 - S-SATA5
SXB1
SXB3
SXB4
SXB5
SXB6
USB0, USB1
VGA
LED Description
LEDM1 BMC Heartbeat LED
LEDPWR Power LED
UID-LED Unit Identifier (UID) LED
Description
Dedicated BMC LAN Port
Onboard CMOS Battery
Front Accessible COM Port Header
4-pin CPU Fan Headers
Supermicro Proprietary Front Control Panel Header
4-pin BMC External I C Header
2
NC-SI (Network Controller Sideband Interface) Connector
Intel VROC Key Header for NVMe RAID
SATA DOM (Disk-On-Module) Power Connector
Trusted Platform Module/Port 80 Connector
Unit Identifier (UID) Switch / BMC Reset Button
10Gb Base-T Ethernet Ports
Intel PCH Powered I-SATA 3.0 Ports with support for SuperDOM (Disk on
Module) devices
Intel PCH S-SATA 3.0 Ports (SW RAID 0, 1, 5, 10)
PCIe 4.0 x8 Slot supported by CPU1 for Supermicro proprietary riser card and
six SATA connections (S-SATA0 - S-SATA5) supported by PCH
PCIe 4.0 x16 Slot supported by CPU1 for the Supermicro proprietary riser card
PCIe 4.0 x16 Slot supported by CPU2 for the Supermicro proprietary riser card
PCIe 4.0 x8 Slot supported by CPU1
PCIe 4.0 x8 Slot supported by CPU1 for the Supermicro proprietary M.2
adapter card
Rear I/O USB Ports (USB 3.2 Gen 1)
Rear VGA Port on the I/O back panel
State: Status
Blinking Green: BMC Normal (Active)
Solid Green: during BMC Reset or during a Cold Reboot
LED On: Onboard Power On
Solid Blue: Unit Identified
19
Chapter 1: Introduction
Default Setting
Open (Normal)
Pins 2-3 (Disabled)
Pins 1-2 (Normal)
Pins 1-2 (Enabled)