Table of Contents
Advertisement
Buzzer tones
A sequence of audible tones will sound
at the end of the programme or if there
is a fault.
The buzzer at the end of a programme
and the warning buzzer in the event of a
fault will sound 4 times at intervals with
a short pause between each set.
The buzzer tones are activated ex-
works.
You can deactivate the buzzer that
sounds at the end of a programme if
you wish. The warning buzzer for faults
cannot be deactivated.
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but-
ton.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Programme options
Press the Turbo button four times.
The Turbo indicator will flash rapidly
four times at intervals.
The flashing sequence in the display
shows whether the buzzer at the end of
the programme is activated or deactiv-
ated.
– : Buzzer tones activated
– : Buzzer tones deactivated
Press the programme selector button
to change the setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
51
Advertisement
Table of Contents
