Buzzer Tones - Miele g 6160 Operating Instructions Manual

Programme options

Buzzer tones

A sequence of audible tones will sound
at the end of the programme or if there
is a fault.
The buzzer at the end of a programme
and warning tones in the event of a
fault sound 4 times at intervals with a
short pause between each set of tones.
The buzzer tones are set to off at the
factory.
If you want the buzzer to sound at the
end of a programme, you will have to
switch it on. Buzzer tones for faults are
always active.
 Open the door.
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the programme selector button
 in and, whilst holding it in, switch
the dishwasher on using the  but‐
ton.
Keep the programme selector button
 pressed in for at least four sec‐
onds until the lower right-hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dure from the beginning again.
58
 Press the button  four times.
The indicator  will flash rapidly four
times at intervals.
The flashing sequence in the display
shows whether the buzzer at the end of
the programme is activated or deactiva‐
ted.
–  : Buzzer tones are switched on
–  : Buzzer tones are switched off
 Press the programme selector button
 if you wish to change the setting.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.