Buzzer Tones - Miele G 6660 Operating Instructions Manual

Buzzer tones

A sequence of audible tones will sound
at the end of the programme or if there
is a fault.
The buzzer at the end of a programme
and the warning buzzer in the event of a
fault will sound four times at intervals
with a short pause between each set.
The buzzer tones are set to off at the
factory.
If you want the buzzer to sound at the
end of a programme, you will have to
switch it on. Buzzer tones for faults are
always active.
 Open the door.
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the programme selector
button  in and, whilst holding it in,
switch the dishwasher on using the
 button.
Keep the programme selector
button  pressed in for at least four
seconds until the lower right-hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
Programme options
 Press the  button four times.
The  indicator will flash rapidly four
times at intervals.
The flashing sequence in the display
shows whether the buzzer at the end of
the programme is activated or
deactivated.
–  : Buzzer tones are switched on.
–  : Buzzer tones are switched off.
 Press the programme selector
button  if you wish to change the
setting.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.
61