Programme options
Buzzer tones
A sequence of audible tones will sound
at the end of the programme or if there
is a fault.
The buzzer at the end of a programme
and the warning buzzer in the event of a
fault will sound 4 times at intervals with
a short pause between each set.
The buzzer tones for warnings are set to
off ex-works.
If you want the buzzer to sound at the
end of a programme you will have to set
it. Buzzer tones for faults are always
active.
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but-
ton.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the pro-
cedure from the beginning again.
54
Press the button four times.
The indicator will flash rapidly four
times at intervals.
The flashing sequence in the display
shows whether the buzzer at the end of
the programme is activated or deactiv-
ated.
– : Buzzer activated
– : Buzzer deactivated
Press the programme selector button
to change the setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.