Maintenance; Maintenance After Each Use - Greencut GS2500 10 Operating Instructions Manual

72 I EN
How to cut the branches of a fallen trunk
Check to which side is the limb bent. Start cutting the side where the branch is bent and finish the
cut from the other side.
How to prune standing trees .
Cut up from the bottom, finish down from above.
Note
Work carefully as the branch may jump back.
Warning
Make sure you have strong support for the feet before starting work. Do not use
stairs.
Do not stretch to cut the branches of a tree. Do not cut to a height greater than
your shoulders.
Always hold the machine firmly with both hands.

MAINTENANCE

Note
Before attempting to clean, inspect or repair this unit; make sure the engine is
off and cool. Disconnect the spark plug wire to prevent the engine from starting
accidentally.

MAINTENANCE AFTER EACH USE.

1. Air filter
To clean dirt from the screens, divide the filter in half and brush with gasoline. If using compressed air,
blew from the inside.
2. Oil filler
Turn the guide bar and check the oil filler port is not blocked.
3. Guide bar
Remove the guide bar and saw dust shake off the groove of it and the oil filler.
Lubricating the sprocket by the lubrication hole located at the end of the guide bar.