Oil Supply Control; Adjusting The Carburetor - Greencut GS2500 10 Operating Instructions Manual

Warning
Avoid close contact with the chain of the saw, as it begins to move once the engine
starts.
Before starting the engine, check the chain is not touching any object.

OIL SUPPLY CONTROL

Warning
Be sure to place the bar and chain to verify the deputy minister of oil. Otherwise,
the rotating parts will be exposed, which is very dangerous.
After starting the engine, run the chain at medium speed and verify that a spill of oil as shown in the
illustration.
Oil chain can be changed by inserting a screwdriver into the hole located on the bottom side of the
clutch. Make the adjustment for working conditions.
Note
The oil tank should be almost empty to run out of fuel. Be sure to fill the oil tank
every time you refuel.

ADJUSTING THE CARBURETOR

The carburetor of this unit has been factory set. However, in some cases it may be necessary to make
minor adjustments to changes in the conditions of use. Before attempting to make adjustments to
the carburetor, check the air filters and fuel are correct.
Make the adjustment using the following steps:
Note
Carry out the adjustment of the carburetor with the string attached.
Chain oil
EN I 69