Greencut GS7200 Instruction Manual page 77

3. Notch up one third of diameter of the tree trunk on the side of cut.
4. Make a felling cut in and opposite the notch, at a level slightly above the bottom of the
notch.
WARNING
Before felling a tree, be sure to warn workers of the danger.
TRACE AND CUT BRANCHES
-
Make sure you have a firm footing. Do not stand on the trunk.
-
Take special care to make this work, since the log may roll to one side.
-
Follow the instructions in the "Safety Standards".
-
Before starting work, check the direction of the bending force and inside the trunk to
be cut. The cut is always on the side opposite to the direction of the bending force to
prevent the guide bar to become trapped in the cut.
A LOG RESTING ON THE GROUND
Realice un corte transversal hasta la mitad del tronco. Luego de
vuelta al tronco y corte por el otro lado.
A TRUNK OFF THE GROUND
In the "A", start cutting from the bottom up to one third of the way
through and finish the cut from above. In the "B", start cutting from
top to one third of trunk diameter and finish the cut from below.
HOW TO CUT THE BRANCHES OF A FALLEN TRUNK.
Check to which side is bent the limb. Start by cutting from the side to
which the branch is bent and finish the cut from the other side.
HOW TO PRUNE STANDING TREES
Cut up from the bottom, finish down from above.
EN I 77