Greencut GS7200 Instruction Manual page 71

FUEL AND CHAIN OIL
FUEL
Gasoline is highly flammable. Avoid smoking or bringing any flame or sparks near the fuel. Be sure to
stop the engine and allow to cool before refueling the united. Select an outdoor ground for fueling
and move the unit to a distance of at least 3 meters (10 feet) from the fueling point before starting
the engine.
Only use normal fuel + 2 stroke engine oil mixture. Unlead fuel 95.
Recommended mixing ratio: fuel 25: oil 1
Exhaust emission are controlled by the parameters and critical engine components (for example:
carburetion, ignition timing and port timing) without adding any major hardware or introducing an
inert material during combustion.
These engines are certified to run with unleaded gasoline.
When using gasoline with a lower octane value than prescribed, there is the danger that the engine
temperature rises and consequently occurs a problem in this, like a piston seizing.
We recommend unleaded gasoline to reduce air pollution for the sake of your health and the
environment.
Poor quality of fuels and oils can damage the sealing rings, lines or fuel tank.
HOW TO MIX THE FUEL
1. Measure the quantities of gasoline and oil that you are going to mix.
2. Put some fuel in a tank of clean and approved fuel.
3. Pour all the oil and shake well.
4. Pour the rest of fuel and shake the mix of some oils may be difficult, depending on oil
ingredients, sufficient agitation is necessary for the benefit of engine life. Be careful, if the
agitation is insufficient, there is an increased danger of early piston seizing due to a mixture.
5. Place a clear indication on the outside of the tank to prevent this can be confused with
gasoline or other substances.
6. Indicate the contents on the outside of the container for easy identification.
EN I 71