Greencut GS7200 Instruction Manual page 74

74 I EN
WARNING
Avoid close contact with the chain of the saw, as it begins to move once the engine
starts.
After starting the engine, run the chain at medium speed and verify that a spill of
oil as shown in the illustration.
Oil flow to the chain could be changed by inserting a screwdriver into the hole
located on the bottom side of the clutch. Make the adjustment for working
conditions.
NOTE
The oil tank should be almost empty to run out of fuel. Be sure to fill the oil tank
every time you refuel.
ADJUSTING THE CARBURETOR
The carburetor of this unit has been factory set.
However, in some cases it may be necessary to make minor adjustments to changes in the conditions
of use. Before attempting to make adjustments to the carburetor, check the air filters and fuel are
correct.
Make the adjustment using the following steps:
NOTE
Carry out the adjustment of the carburetor with the string attached.
(1 )Needle ¨"L"
(2) Needle "H"
(3) Screw idling
Chain oil