Greencut GS7200 Instruction Manual page 68

68 I EN
EXPLANATION OF THE LABELS ON THE MACHINE
For safe operation and maintenance, the following symbols on the machine have been embossed.
Be careful not to make any mistakes regarding these symbols.
It is time to replace mix gasoline.
Location: Near the fuel cap.
LO--O Notice that it is time to re-add oil on the chain.
Location: Near the oil cap.
STOP
If you set the switch to position "O", the engine will stop immediately.
Location: The left rear of the unit.
If you pull the choke (Behind the rear handle) to the point marked with an arrow,
you can adjust the machine's ignition as it follows:
CHOKE
- 1st stage position: Ignition when the engine is warm
START
- 2nd stage position: Ignition when the engine is cold
RUN
- Location: In the high part of the air filter.
H
Use the screw marked with an "H" to adjust the saw's high speed.
L
Use the screw marked with an "L" to adjust the saw's low speed.
T
The screw at the left of the trademark "T" is the screw idle adjustment.
Location: Left side of the rear handle.
Shows the direction in which the chain brake is released (white arrow) and
activated (black arrow).
Position: In the front of the chain cover.
MIN_MAX: If you rotate the shaft using a screwdriver, follow the direction indicated
by the arrow to the "MAX" if you want more oil on the chain or to the "MIN" to
flow less.
Position: Under the unit.