FiT REMOTE DISPLAY Instruction Manual page 44

INSTRUCTION MANUAL
Error code Error message displayed
49-09, 49-0A Motor error
49-0B Motor error
Pinion change detected
49-0C Motor error
Tampering detected
49-0D Motor error
49-xx Motor error
4A-xx Motor temperature error
4B-xx Motor speed sensor error
4C-xx Motor torque sensor error
4D-03 Gear error
Release pedals
FIT_Manual_Remote_Display_Pinion_V3_en | Version 03 | 24.10.2023
FIT REMOTE DISPLAY PINION
Action / Restriction
1. Check if one or both trigger buttons are pressed
constantly, if so: Release buttons.
2. Restart the system.
3. If the problem persists, please contact your
specialist dealer.
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
1. Check mounting position of the magnet and
speed sensor.
2. Start calibration via display gear menu (follow
instructions).
3. Restart the system.
4. If the problem persists, please contact your
specialist dealer.
1. Restart the system.
2. Check light cables and lights for short circuit;
check installed lamps for compatibility with the
bike and replace them if necessary.
3. If the problem persists, please contact your
specialist dealer.
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
1. Switch the system off.
2. Allow the motor to cool down and, if necessary,
clean the motor's ventilation vents.
3. Switch on the system.
4. If the problem persists, please contact your
specialist dealer.
1. Restart the system.
2. Check mounting position of the magnet and
speed sensor.
3. If the problem persists, please contact your
specialist dealer.
1. Restart the system with no pressure on the
pedals.
2. If the problem persists, please contact your
specialist dealer.
1. Release pedals so that wheel can shift into the
required speed for the pushing aid, wait 3
seconds.
2. Restart the system with no pressure on the
pedals.
3. Start calibration via display gear menu (follow
instructions).
4. If the problem persists, please contact your
specialist dealer.
44