Planet Networking & Communication XGS-6320 Series User Manual page 36

 Connecting the Fiber Cable
Insert the duplex LC connector into the SFP/SFP+ transceiver.
1.
Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
2.
Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the SFP/SFP+
3.
transceiver is operating correctly.
Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or Media Converters, user
4.
has to set the port Link mode to "10G Force", or "1000M Force".
 Removing the Transceiver Module
Make sure there is no network activity anymore.
1.
Remove the Fiber-Optic Cable gently.
2.
Lift up the lever of the MGB module and turn it to a horizontal position.
3.
Pull out the module gently through the lever.
4.
Never pull out the module without lifting up the lever of the module and turning it to a horizontal
position. Directly pulling out the module could damage the module and the SFP/SFP+ module
slot of the Managed Switch.
Figure 2-2-5: How to Pull Out the SFP/SFP+ Transceiver
User's Manual of XGS-6320 Managed Switches
36