Planet Networking & Communication XGS-6320 Series User Manual page 252

The displayed settings are:
Object
 Port
 Flow Sampler Enabled
 Flow Sampler
Sampling Rate
 Flow Sampler Max.
Header
 Counter Poller
Enabled
 Counter Poller Interval
Buttons
: See description under Owner.
: Click to refresh the page. Note that unsaved changes will be lost.
: Click to apply changes. Note that sFlow configuration is not persisted to non-volatile memory.
: Click to undo any changes made locally and revert to previously saved values.
Description
The port number for which the configuration below applies.
Enables/disables flow sampling on this port.
The statistical sampling rate for packet sampling. Set to N to sample on average
1/Nth of the packets transmitted/received on the port.
Not all sampling rates are achievable. If an unsupported sampling rate is
requested, the switch will automatically adjust it to the closest achievable. This
will be reported back in this field. Valid range is 1 to 32767.
The maximum number of bytes that should be copied from a sampled packet to
the sFlow datagram. Valid range is 14 to 200 bytes with default being 128 bytes.
To have room for any frame, the
bytes larger than the maximum header size. If the
not take into account the maximum header size, samples may be dropped.
Enables/disables counter polling on this port.
With counter polling enabled, this specifies the interval - in seconds - between
counter poller samples. Valid range is 1 to 3600 seconds.
252
User's Manual of XGS-6320 Managed Switches
maximum datagram size should be roughly 100
maximum datagram size does