Planet Networking & Communication XGS-6320 Series User Manual page 27

■ 10 Gigabit TP interface
100/1G/2.5G/10G BASE-T Copper, RJ45 twisted-pair: Up to 100 meters
■ IEEE 802.3bt TP interface (Only for XGS-6320-8UP4X)
802.3bt PoE++ injector function which is capable of delivering 95W PoE power per port
■ 10 Gigabit SFP+ slot
1G/2.5G/10GBASE-SR/LR mini-GBIC slot for SFP+ (Small Factor Pluggable Plus) transceiver module support distance
from 300 meters (multi-mode fiber) to 10 kilometers (single mode fiber).
■ Console port
The console port is an RJ45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP address setting, factory reset, port management, link status and system
setting. Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
■ Reset button
The front panels of the XGS-6320 come with a reset button designed for rebooting the Managed Switch without turning off
and on the power. The following is the summary table of reset button functions:
Reset Button Pressed and Released
< 5 sec: System Reboot
> 5 sec: Factory Default
The reset buttons of the XGS-6320 are located on the front of their panels.
User's Manual of XGS-6320 Managed Switches
Function
Reboot the Managed Switch.
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
Default Username: admin
。
Default Password: admin
。
Default IP Address: 192.168.0.100
。
Subnet Mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
27