Entering The Platform With Auto-Fold Ramp; Operating The Platform Controls; Exiting The Platform - Harmar Mobility VPL400-X Owner's Manual

ENTERING THE PLATFORM
WITH AUTO-FOLD RAMP
Enter platform through opening. Be sure all body
parts and wheelchair parts are completely inside the
platform. When you control the lift to go up, the
auto ramp will gradually close and be complete after
13" of vertical travel. See Figure 3-2.
Figure 3-2
OPERATING THE
PLATFORM CONTROLS
Once you are on the platform, locate the Platform
Controls on the side panel. If the unit has a key
switch, insert the key and turn the key to the "On"
position. See Figure 3-3.
Figure 3-3
HIGHLANDER 400-X: SECTION 3
Once you have confirmed that your unit is on, simply
press the desired (up or down) arrow on the blue
paddle. The lift will move as long as the paddle control
is pressed until you come to a full stop at the desired
landing.
CAUTION
!
If you release the blue paddle switch and the unit
continues to move, press the Red Emergency Stop
Button on the control panel to stop immediately.
WARNING
!
Do not hold onto the top of the side panel or gate
during transport. Keep feet, hands, arms, legs
and body well within the confines of the platform
during transport.

EXITING THE PLATFORM

Once you are at the desired landing, the lift will stop
and you may release the brakes on your mobility
device. When ready to exit, if desired, turn the key
switch off and remove the keys.
If your platform has a platform gate or you come to
a landing gate or door, those will be able to be
opened by pushing outward.
CAUTION
!
Check to make sure the platform is level with the
landing. If not, please contact a dealer for assistance.
NOTE: If your platform has an automatic folding ramp, it
will automatically deploy only at the lower landing.
Once you have exited the platform, ensure the gate
or door has closed all the way. Call/Send controls
will not work unless doors are closed.
VPL400-X:
OPERATION
Owner's Manual
9
05MAY23 | 610-00103 A