Table of Contents
Advertisement
7
Installing the Platform Guard Panels
Step 1
Insert the guard panel posts in the pockets in
the platform. The smooth side of the guard panel
faces toward the center of the platform. Bolt each
post in place with (2) 5/16-18 x 2" and (1) 1/4-20 x 2"
hex head bolts.
If you have a 90 degree exit platform, install
the end guard panel using the provided
bracket and bolt to inner guard panel.
Step 2
Install the platform control box on the rear
guard panel using screws and nuts through
the panel.
Step 3
Plug in the harness for the platform control
box. Secure the harnesses under the clip on
top of the carriage flange.
Installing Fixed
Ramp
Step 1
• Position the ramp after the lift is in its final
location.
• Maintain a gap of 3/8" to 3/4" between the
ramp and platform.
• Drill a pilot hole into the concrete and
fasten using supplied concrete lags through
ramp flanges.
Advertisement
Table of Contents
