Al560 & Al560Xl Platform Adjustments - Harmar Mobility AL010 Installation & Service Manual

The cradle's flat bar and platform ramp should contact
the wheel between specific positions: See Figure 6-7.
7 5 and
(smallest gap)
Figure 6-7
Test scooter securement with hold-down foot. Once
satisfied with position of scooter's rear wheels, be
sure to tighten ALL fasteners.
AL560 & AL560XL PLATFORM
ADJUSTMENTS
The thread must protrude out of the top of the nylon
portion of all nuts.
NOTICE
For adjustment purposes, the platform component
screws and nuts are loose. You MUST tighten the
platform component screws and nuts before use.
See Figure 6-8.
8 4 o'clock
(largest gap)
OUTSIDE VEHICLE LIFTS: SECTION 6
LIFT ADJUSTMENTS
x 12
1. Estimate the chair's center position depending
on the entry preference (driver's side or
passenger's side). Locate the drive wheel's
position. See Figure 6-7. Adjust the two main
cradle positions to match. Capture the smaller
wheels on the two larger platform skins.
2. Position the chair onto the platform. Verify that
the chair is secure and does not move in any
direction once positioned between the platform
skins and the cradles. See Figure 6-9.
Outside Vehicle Lifts: Installation & Service Manual
06DEC19 | P/N: 630-00106 REV A
x 12
Figure 6-8
Figure 6-9
23